Post by chuy on May 8, 2019 8:32:54 GMT -7
Looking for input for the scale I am building.
I am already working on a more compact case, this thing is a bit big.
I am creating "pads" for each wheel at the each scale.
The rear pads will have some sort of way to keep the wheels from moving. Either they will be concave or have "stops" in front and back.
The front pad will go from side to side to accommodate left and right DFWs. It will also be wide enough for 4.5", 4.75", and 5" wheel bases.
The program currently has the ability to calculate center of mass but this display is too small. There is about a $12 difference ($2 vs $14) in a bigger display. The current one is 0.96" and the larger one is 2.42" Do you think it is worthwhile to add center of mass (both x and y) or is weight the only important thing out there?
I also need to add the tare button, forgot that.
I am already working on a more compact case, this thing is a bit big.
I am creating "pads" for each wheel at the each scale.
The rear pads will have some sort of way to keep the wheels from moving. Either they will be concave or have "stops" in front and back.
The front pad will go from side to side to accommodate left and right DFWs. It will also be wide enough for 4.5", 4.75", and 5" wheel bases.
The program currently has the ability to calculate center of mass but this display is too small. There is about a $12 difference ($2 vs $14) in a bigger display. The current one is 0.96" and the larger one is 2.42" Do you think it is worthwhile to add center of mass (both x and y) or is weight the only important thing out there?
I also need to add the tare button, forgot that.
